Official Luthiers Forum! • View topic

Board index » Luthiers Forum Rooms » Guitar Building Forum

All times are UTC - 5 hours

Forum rules

Be nice, no cussin and enjoy!

Hardware For Molly

Page 2 of 2

[ 26 posts ]

Go to page Previous 1, 2

Print view

Previous topic | Next topic

Author

Message

Stuart Gort

Post subject: Re: Hardware For Molly

Posted: Thu Feb 13, 2014 12:32 am

Brazilian Rosewood

Joined: Fri Jan 15, 2010 3:34 pm
Posts: 2047
First name: Stuart
Last Name: Gort
Country: USA
Focus: Build
Status: Semi-pro

nyazzip wrote:

i understand the anodized finish was ground off, leaving a smooth shiny surface in relief areas- but on the anodized surfaces, did you have to hand finish them smooth first, to remove mill marks, or is the CNC machine that good that it can produce "ready for paint" parts...?

Those were all anodized without any hand work. The machine is a 13,000 lb. production machine. It's very accurate so with proper planning, machining marks can be minimized or eliminated. A lot of it has to do with the tool selection...and having a decent library of choices.

_________________
I read Emerson on the can. A foolish consistency is the hobgoblin of little minds...true...but a consistent reading of Emerson has its uses nevertheless.

StuMusic

These users thanked the author Stuart Gort for the post: nyazzip (Thu Feb 13, 2014 3:40 pm)

Top

Page 2 of 2

[ 26 posts ]

Go to page Previous 1, 2

Board index » Luthiers Forum Rooms » Guitar Building Forum

All times are UTC - 5 hours

Who is online

Users browsing this forum: DennisK and 30 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to: